Steel platform based on the actual site and specific requirements, can be designed into single layer or multilayer, multilayer is commonly 2-3 layers, we should pay more attention to the use safety of shelves.
1, steel platform should be set limit load card, especially with hydraulic lift platform steel platform, more need to be prominently marked restrictions;
2, steel platform on point and upper nodes must be in the building, and shall not be set on the scaffolding and other construction facilities, support systems shall not be connected to the scaffold.
3, steel platform of concrete beam and slab should be put aside some built-in parts, and with the platform of the bolt connection.
4, the Angle of the wire rope and the platform level appropriate for 45 degrees to 60 degrees.
5, the upper nodes of steel platform beam should be calculating the tensile strength, to ensure the safety of buildings and the platform.
6, steel platform should be used when the snap ring, shall not make the hook hook the platform rings directly.
7, when installation, steel platform, steel wire rope should use special hanging on the hook, other ways when card shall not be less than 3, buildings should add line on acute mouth round tie wire rope soft mat, steel platform outside the mouth should be slightly higher than the inside.
8,around steel platform need to install the fence, but when necessary also need to install the Seine, prevent falls in people or goods.